Radio HT ICOM IC V80
https://blogger.googleusercontent.com/img/b/R29vZ2xl/AVvXsEiUUBUp4-qum427b4BsZDlBfW-H6x_xTC1qLQh3eOZcGaicwyuTCislBQMWiZxdTnBo-qHIlZnIFlrj9H3rBkWSfnczTE_wdx_4EOH_WxDxVOHFJR-TqkRwZsdcA6bq02Df24ranqlOaOMQ/s72-c/ICOM+v80.jpg
Specifications
General | |||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|
Frequency range |
Tx 144–148 MHz Rx 136–174 MHz* *Guaranteed range 144–148 MHz |
||||||||||
Type of emissions | F2D/F3E | ||||||||||
No. of memory channels | 207 (incl. 6 scan edges and 1 call) | ||||||||||
Frequency stability | ±2.5ppm (-20°C to +60°C) at 25° C | ||||||||||
Operating temperature range | –20°C to +60°C; –4°F to +140°F | ||||||||||
Power supply | 7.2 V DC | ||||||||||
Current drain (at 7.2V DC) |
|
||||||||||
Antenna impedance | BNC (50Ω) | ||||||||||
Dimensions (proj. not incl.) |
58(W)×112(H)×30(D) mm 29/32(W) × 4313/32(H) × 13/16(D) in |
||||||||||
Weight (approx.) | 360 g; 12.7 oz (with BP-264 and Ant.) |
Transmitter | |
---|---|
Output power (at 7.2 V DC) |
5.5 W (High) 2.5 W (Mid) 0.5 W (Low) |
Spurious emissions | Less than –60 dB |
Max. frequency deviation | ±5.0 kHz/±2.5 kHz (wide/narrow) |
External mic. connector | 3-conductor 2.5 (d) mm (1/10″) / 2.2 kΩ |
Receiver | |
---|---|
Sensitivity | 0.14 µV (typ.; at 12dB SINAD) |
Squelch sensitivity | 0.1 µV (typ.; at threshold) |
Selectivity | 70dB/50dB typical (wide/narrow) |
Intermodulation | 70dB/65dB typical (wide/narrow) |
Spurious and image rejection | 75dB (typical) |
Audio output power
(at 10% distortion) |
450mW with an 8Ω load |
External speaker connector | 3-conductor 3.5 (d) mm (1/8″) / 8Ω |
Applicable U.S. Military Specifications
Icom makes rugged products that have been tested to and passed the following MIL-STD requirements and strict environmental standards.Standard | MIL 810 F | |
Method | Proc. | |
Low Pressure | 500.4 | I, II |
High Temp. | 501.4 | I, II |
Low Temp. | 502.4-3 | I, II |
Temp. Shock | 503.4 | I |
Solar Radiation | 505.4 | I |
Rain | 506.4 | I, III |
Humidity | 507.4 | – |
Salt Fog | 509.4 | – |
Dust | 510.4 | I |
Vibration | 514.5 | I |
Shock | 516.5 | I, IV |
Ingress Protection Standard: Dust and water – IP54 (dust-protection and water resistant)
All stated specifications are subject to change without notice or obligation.
Supplied accessories
- Battery case or battery pack*
- Desktop charger*
- Antenna
- Belt clip